Handmade Ring Bearer Pillow

• ¼ inch and ½ inch Decorative Satin Ribbon and Lace
• 8 to 10 inch square of White or Off-White Fabric (Silk, Satin, Brocade or Same Fabric as the Bridal Dress)
• Embroidery Needles
• Embroidery Thread
• Glue
• Lace Ruffle
• Lucky Charms
• Scissors
• Sewing Needles
• Thread to Sew
• Two to Three Polyester Batting Squares (Same as Fabric Square in Size)

• Do any embroidery and needlework on the right side of the fabric square.
• Sew on lucky charms, small ribbon and lace to the fabric face.
• Sew on the straight edge of the lace ruffle along the fabric edge, on all four sides, wrong sides together.
• Now, put the wrong sides of both the fabric pieces together and sew them to form the pillow on three sides.
• Turn the pillow inside out (from the open side) and stuff it with polyester batting.
• Fold the edge of the open side towards the pillow back for about half an inch and stitch it close using slipstitch.
• Glue on the ¼ inch satin or silk ribbon to the center of the pillow top.
• Stitch the ribbon to the pillow at the center point.
• Glue on a ribbon bow made from the same ribbon over the stitching to hide it.
• The two ribbon strands can be used to loosely tie the wedding rings to the pillows